I would like to set the light level of a huge room, with a light level of 7. Torches dont fill the whole area and ender chest are not full blocks. Is this possible?
Is there a command to set the light level of an area? Torches look ugly and I cant place them in all the spots i need to.
Other light blocks dont fit in either
ok, so, I have a hidden piston door that I made that has an integrated t-flip-flop, but I want the button on the outside to open it (and close if neccesary, but shouldn''t be) on the rising action of the button, then a presure-plate on the inside close it on the rising action, then on the way out, open on rising action from the presure plate, and close on the falling action of the presure plat. also, the presure plate must be as close as possible to the entrance.
[the most compact hidden piston door is 4stickeys facing towards the hallway, two facing the entrance, and a "U" of redstone on top with a repeater set on 3 for the line for the 'back' pistons, I hope you can understand that XP and that's for reference]
I've go a system that works, mostly, for now that takes up 5x5x8+1 down right now, prety compact, and not excesivly noisy, when I can, I'll link a vid of it for reference if needed
The levers with torches on their block are ones that have to be off and the levers that power repeaters have to be off inorder for the output to be on. The red is there because a signal can only travel 15 blocks before having to be renewed again by a repeater (or something else). You can also replace repeaters with dust
1
0
0
0
0
Other light blocks dont fit in either
0
0
images: http://imgur.com/a/tRg2K
0
2
0
Just attach both inputs to the t flip flop.
1
light blue is input. right repeater is output. make sure the piston is a sticky piston
1
A block swapper wont help you here.
Also hipster fence
0
The levers with torches on their block are ones that have to be off and the levers that power repeaters have to be off inorder for the output to be on. The red is there because a signal can only travel 15 blocks before having to be renewed again by a repeater (or something else). You can also replace repeaters with dust
0
0