I was wondering if someone could help me with a problem I've run into with my locking door.
I have an AND gate made with both inputs each coming from a single lever; one outside (open/close) and one inside (lock/unlock).
The output is connected to my door, but i run into my problem trying to hide the wiring connected to my door. When i put down blocks to complete the floor just inside the door it cuts off the connection to the output of the AND gate.
So, I was wondering if there is any way to make an AND gate with my same inputs that are working, but instead of the output wired straight to the door, if I could lead the output wire to the block underneath my door and transmit up using another red torch.
I've tried to do this and the door is powered by the torch, but the AND circuit doesn't seem to work the way it should this way.
Also, is it true that you can put glass over/on top of the wiring and it will not break the connection?
0
I have an AND gate made with both inputs each coming from a single lever; one outside (open/close) and one inside (lock/unlock).
The output is connected to my door, but i run into my problem trying to hide the wiring connected to my door. When i put down blocks to complete the floor just inside the door it cuts off the connection to the output of the AND gate.
So, I was wondering if there is any way to make an AND gate with my same inputs that are working, but instead of the output wired straight to the door, if I could lead the output wire to the block underneath my door and transmit up using another red torch.
I've tried to do this and the door is powered by the torch, but the AND circuit doesn't seem to work the way it should this way.
Also, is it true that you can put glass over/on top of the wiring and it will not break the connection?
Please help me!
Thanks