Minecraft Forums

I am on Minecraft right now (Xbox 360 of course) and I have an enchantment room with bookcases all around it, behind the bookcases are pistons that will PULL the bookcases away to lower the full potential of the enchanting table. (Thus useful for players who want more lower level options when they do not have enough experience) And I want to keep the bookcases square. For example, all the bookcases get PULLED out except the side that is closest to entrance, when the left and right side are pulled out, it leaves a open spot on each ends of the bookcases that I am standing on, now I have pistons set up to where it will push an extra set of bookcases outward to fill in these spots. But when I go to close the bookcases back to normal, the extra set doesn't go back in BEFORE the original ones do, this is caused by the pistons being delayed at he beginning, so the pistons PUSH AFTER the original ones span out. But when closing back in, it doesn't happen til after the originals are pushed back in. Causing the pistons to mess up and mess up the book cases.

So, does anyone have any recommendations on how I can get the extra set of pistons to go back in before the originals get pushed back in? Whilst at the same time be pushed right after the original pistons get pulled out?

Images

(I took out the bookcases so you have a better understanding on where the pistons are and how they are placed)

Before pistons are pulled out, extra set sits back.


After pistons have pull bookcases out and extra set fills in the spots


After I revert the bookcases back, the extra set does not go back in first because of the delays. Causing unintended results.