I have yet to see a fully functional quad vertical piston extender on youtube, and the only one I found that worked didn't include a block on top of the fourth piston. If anyone is able to find or create a method of making a quad vertical piston extender, I would be very thankful.
P.S. As an additional request an ONLY if the above is found, cause if not requesting this will become moot. I'm trying to figure out the following.
A = Sticky Piston B = Stone Block
Side view: BBBBBB AAAAAA AAAAAB AAABBB ABBBBB
In addition I'm hoping I could have it two wide, the same thing on the other side. If it's impossible that's ok too. I'm just wondering if it could be done.
The part to look at in the old post is the diagram of the required redstone pulses. There are lots of newer designs, but all create pretty much the same sequence of redstone signals.
Keep looking, and especially, search the forums and not youtube. There's lots of good examples here.
P.S. As an additional request an ONLY if the above is found, cause if not requesting this will become moot. I'm trying to figure out the following.
A = Sticky Piston
B = Stone Block
Side view:
BBBBBB
AAAAAA
AAAAAB
AAABBB
ABBBBB
In addition I'm hoping I could have it two wide, the same thing on the other side. If it's impossible that's ok too. I'm just wondering if it could be done.
Here's the original post: 4-high x 8 Wide Raising/Lowering Portcullis
The part to look at in the old post is the diagram of the required redstone pulses. There are lots of newer designs, but all create pretty much the same sequence of redstone signals.
Keep looking, and especially, search the forums and not youtube. There's lots of good examples here.